Cybertek OP6035A Optically Isolated Probe: Performance Upgrade
Source: Probemart 2024-06-11 Views: 1205
Cybertek optically isolated probe OP6035A delivers substantially improved performance after upgrade
Introduction: With silicon carbide(SiC)and gallium nitride(GaN)devices being increasingly used, new testing challenges continue to emerge, and traditional silicon(Si)testing methods can no longer meet testing requirements, and the optically isolated probe is the best choice.
In the previous issue, Probe Home reviewed CybertekCybertekoptically isolated probeOP6035A, click the link to view the original data report:
http://www.probemart.com/portal/test/show.html?id=42
Before the upgrade, based on laboratory measured data, the performance was not ideal, and the overall average error was approximately3.901%. After the manufacturer's performance upgrade,the test data accuracy improved by one level,the overall average error is approximately0.5%. The specific test data can be viewed by clicking the link:
http://www.probemart.com/portal/test/show.html?id=51
In addition, we also compared the noise floor before and after the upgrade; after the upgrade,the noise floor was also reduced by about half. The specific waveforms are shown in the figure below:
Noise floor waveform before upgrade:(measuredCrosstalkwaveform; red is the Cybertek optically isolated probe, yellow is the Micsig optically isolated probe)

Figure1: pre-upgrade testCrosstalkNoise floor waveform
Figure2: Pre-upgrade testCrosstalkZoomed-in detail of noise floor waveform
Post-upgrade noise floor waveform:(MeasuredCrosstalkwaveform; orange is Cybertek optically isolated probe, red is Micsig optically isolated probe)

Figure3: Post-upgrade testCrosstalkNoise floor waveform

Figure4: Post-upgrade testCrosstalkZoomed-in detail of noise floor waveform
Summary:From the test data, the overall performance of the upgraded Cybertek optically isolated probe has indeed improved by one level,In terms of both noise floor control and precision control, it is very good.
Finally, in today's increasingly complex international competitive environment, Probemart hopes that more and more domestic products that are a source of pride will support China's “quality” manufacturing and bring more possibilities to our country's scientific and technological development!
PCIM Europe 2026, Nuremberg: IWATSU and PMK at Booth H7-157
2026-06-15
APEC 2026: 41st IEEE Applied Power Electronics Conference and Exposition
2026-03-15
Semicon China 2026, Shanghai New International Expo Centre (SNIEC)
2026-03-11
WiPDA Asia 2025, Beijing International Convention Center, 15 August
2025-08-06
















